Printer problem, which often occurs in canon printer

I think Canon is a favorite printer, can be said of the favorite because this printer has good print quality, and fast. But maybe there are a lot of issues going on but not as often as other brands "do not say the name brand":-d one of the problems I experienced this morning on the printer canon ip 1980 which is when they want ngeprint it says -> "vacuum ink full service contact center "or the ink absorber is full well the problems which service center should be in contact :). Finally I tried googling and found articles that can overcome these problems, the results of googling that ane can to address issues that often arise in canon printer:

1. Blinking, Proofing indicator is flashing when printer is turned on
Usually this disease struck Canon iP1200, IP1300, iP1600, iP1700, i255, Lightweight Solution, this solution means you should do every time you turn on the printer, because this is only temporary. When your printer is disconnected from the power outlet, then it will re-emerge blinking. But there is not no harm in doing this step, if you are not familiar with ways to reset the printer using the software.
Unplug the power cord from your printer.

• Press and hold the Power button, while you replace the power cord. The power indicator lights appear yellow. Release the power button when you have finished installing the power cable. Then press the power button again to turn on your printer.
  Ensure your printer is not blinking anymore. But when your printer is disconnected from the power outlet, then blinking will appear, and you just repeat the above steps.

Software Solutions, you can overcome this by using a blinking disease GeneralTool software specifically for iP 1300 and iP 1700. By using this software, blinking usually be resolved permanently, meaning you do not need to be repeated as the mild solution above.

2. Blinking, blinking when the ink runs out, or when the contents of the ink finishes

Usually this disease struck Canon iP 1880 printer, and occurs when the ink runs out or when you are done filling ink. Or even the ink is not depleted, but blinking is often struck iP 1880. One solution:

• Press and hold the RESUME button for about 1 to 2 minutes
  Then open the lid or cover your printer.
  Open his first Cartridge and reinstall it
  Close the printer cover
  Turn off and then turn back

3. Letter Print results dashed (striped), uneven

Try performing cleaning several times, if that does not work well, you wash your catrige manually.

• Best solution: based on the experience of some users, it is already time for you to replace your printer Catrige

4. Addressing the ink absorber is full Canon IP1700 and IP1200
solution:

• Turn off the printer and unplug the power cord
  Press and hold the power button (not released) while then plug the power cord back
  When the power button is pressed and the power cable has been plugged back, press the resume button twice (in a row)
  Release the power button
  completed

Now your computer will detect a new printer, follow the steps requested until later installed a new printer.

5. Solution The waste ink absorber is almost full and the ink absorber is full Canon iP3000 and IP2000
solution:

• Turn off the printer
  Press the reset button and then press the power button
  Press and hold the power button and then release the reset button
  Press the button again resume two times in a row and then release both buttons (the reset button and the power button)
  Green indicator will appear
  When the indicator is green, then press the resume button 4 times
  Press the power button, the printer off (turn off), if not press the power button again
  Printer back to normal.
  
  
  Taken from various sources